axle

Good Afternoon, Recetly i have bought some axle sliders from R&G for the MT 07. The problem began when they arived, i notice that there is a bar on them that goes inside the axle wheel and shaft pivot. The problem is in Brazil those parts are solid. So there is no place to them to be instaled...

Hi guys, I wanted to take of my rear wheel to balance it as I had a small crash and the wheel wasn't balanced anymore. I loosed up the nut and made around 3 turns. After which the nut got stuck. I thought that I need to use the bigger wrench so I got it. It went a little more but the align...

I have just checked the wheel alignment on my bike and discovered that it was slightly wrong. I hasten to point out that, since buying it from Gaz2212, this is the first and only thing thing that I have found to be (slightly) wrong. Fortunately, GAZ had fitted Gilles swing arm chain tensioners...

I've had my MT for a few weeks now, so I've had enough time to get an impression of the mods I've added. 1) Radiator screen. Easy, cheap, and to judge by the number of dings the radiator already had (it's an ex-demo bike), necessary. 2) Oxford heated grips. Warm hands are always a worthwhile...

Novice rider but been driving for 30 years so not a complete idiot and I don't plan on dropping my bike any time soon if at all! But, just in case, what are the best protection options. I've seen the crash bobbins that fit to the frame and also the engine sliders, are both necessary or is one...