Eddieh93
New member
Hi all,
So finally got most of my modifications on still got a few bits to add on but here goes anyway.
First things first was to sort them long levers out so I brought a pair of £15 ebay special levers.
Next thing was to get the ghastly foot pegs sorted, there is something about the big bulky rubber foot pegs that I hate so went for another set of ebay special foot pegs (can you tell I love ebay?)
While were on the subject of foot pegs I got rid of the passenger foot pegs and got a Bruudt set of cover plates with the rear brake resevior adapter.
Had a little trouble with the Bruudt resevior adapter as the reservoir just touched the frame but I have angled it slightly to accommodate not a major issue.
I also brought all the R+G crash bobbins the rear axle stand sliders and front axle sliders because you never know and I have crashed before and the cost of repair was expensive and don't fancy that again.
Next on the agenda was a tail tidy, as I had brought the Bruudt cover plates I went for the Bruudt tail tidy and I must say was impressed with the sturdy build quality. It all fitted spot on the only slight issue I had was getting the cover underneath the tail back on with the 4 push clips It. seem like it was holding a lot of pressure for such a small panel...anyway, finally got it on with a bit of Pop-eye persuasion and some RTV (aviation glue).
I have got a couple of more thing I want to do
1. Moto Cage screen
2. Radiator Guard (ordered)
3.Carbon Fibre Heel plates (i'll see what they look like after i install them might stick with orginal.)
4. Zard or SC Project exhaust (still undecided)
Didn't take me long to fit that tail tidy which was done last night and here was the aftermath........
So here is the finished project...........for now.
Thanks guys, any questions just ask me.
Ed
So finally got most of my modifications on still got a few bits to add on but here goes anyway.
First things first was to sort them long levers out so I brought a pair of £15 ebay special levers.
Next thing was to get the ghastly foot pegs sorted, there is something about the big bulky rubber foot pegs that I hate so went for another set of ebay special foot pegs (can you tell I love ebay?)
While were on the subject of foot pegs I got rid of the passenger foot pegs and got a Bruudt set of cover plates with the rear brake resevior adapter.
Had a little trouble with the Bruudt resevior adapter as the reservoir just touched the frame but I have angled it slightly to accommodate not a major issue.
I also brought all the R+G crash bobbins the rear axle stand sliders and front axle sliders because you never know and I have crashed before and the cost of repair was expensive and don't fancy that again.
Next on the agenda was a tail tidy, as I had brought the Bruudt cover plates I went for the Bruudt tail tidy and I must say was impressed with the sturdy build quality. It all fitted spot on the only slight issue I had was getting the cover underneath the tail back on with the 4 push clips It. seem like it was holding a lot of pressure for such a small panel...anyway, finally got it on with a bit of Pop-eye persuasion and some RTV (aviation glue).
I have got a couple of more thing I want to do
1. Moto Cage screen
2. Radiator Guard (ordered)
3.Carbon Fibre Heel plates (i'll see what they look like after i install them might stick with orginal.)
4. Zard or SC Project exhaust (still undecided)
Didn't take me long to fit that tail tidy which was done last night and here was the aftermath........
So here is the finished project...........for now.
Thanks guys, any questions just ask me.
Ed
Last edited: