Connecting Scottoiler


Ralph

New member
Use the same connection on the throttle body's used for
the throttle body sync, some bike don't have a pipe on the
right side so connect to that if it as a pipe both sides use
a T piece, you can get them for air pipes used on fish tanks.
 

Ralph

New member
Yes but check the one on the other side as it may just have a cap on it so you wont need a T piece.
 

chase106

New member
What is the air box flap?

The pictures is from google, in my MT the left side is connected to the air box or the fuel tank, and the right side go into a small white round plastic which I do not know what he was doing.
 

Ralph

New member
If it's there it shuts a flap at certain revs and throttle openings to
pass noise tests yours wont have the silver round vacuum actuator
on the air box and the snorkel will point back instead of forward.

 

chase106

New member
Some pictures of my bike

Left side
20150725_175203.jpg
Right side Throttle
20150725_175248.jpg
Right side
20150725_175258.jpg
Under the seat
20150725_175528.jpg

So you're saying under the seat I can connect the Scottoiler to the line of the round vacuum actuator
on the air box?
 

Ralph

New member
No that only as vacuum at certain times you need to tee into one of the first two.
I thought the pic with the rubber cap instead of the pipe was your bike as I said some
are different .

Get a T connector if there's not one in the kit,
Pull the pipe off and connect it to one end of the T
Run a short pipe from the T to the org connection on the bike.
Connect the Scot oiler to the other connection on the T
using a short bit on new pipe saves cutting the org one.
 

badger27

New member
If you give scot oiler a ring they will email you the instructions with photos for the MT 07. They are very helpful
 


Top